General information
Category:
Reports & Report designer
Thanks Dragan,
I'll follow your suggestions tonight.
Harry
>
>The current alias when you run the report is not the alias that you're printing. So it's reprinting the data from the alias you wanted, once for every record of the alias you're going through... which is a wrong one.
>
>Possible causes:
>- your code selects some other table at the last millisecond before running the report
>- your code in report's dataenvironment selects some other table and then continues running the report on it
>- you have a grid which has the focus, and it chooses to refresh when you run the report. Your report prints the same record for each record of the grid's underlying alias.
>
>Cure for first two is to just fix the code, or lose the alias in report's fields. For the third, get the focus off the grid before running the report.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only