General information
Category:
Installation, Setup and Configuration
Did you install the VFP 9 SP2 runtimes on all the computers?
>I have just switched to VFP 9.0 SP2. Previously, I was using 7.0. I compiled my application in 9.0, build an .EXE and ran on a bunch of computers running XP SP2. It works fine on most of the computers except a few. When, you dbl click on the executable, it just beeps, nothing happens. Can someone tell me what is going on. Please Helpppppp.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only