General information
Category:
Forms & Form designer
>>I have a grid on page two of a form. I'm using it to
>>browse records added to a temporary table. If I start
>>out with the temporary table populated and go to the
>>page containing the grid, it shows the records correctly.
>>If I then clear (ZAP) the table (on page on) and then
>>add a record to the table (so now there's only one
>>record in the table) and switch to page two the grid
>>shows that there are no records in the table.
>>
>>To get any records to show at all I have to close the
>>form and re-run it.
>>
>>The grid's Refresh event is being fired.
>>
>>What's happening?
>>
>> ...kt
>
>
>what recordsource type is the grid?
>
>Jeff
RecordSourceType = 1 - alias
RecordSource = ProfileSrc (my temp table)
ReadOnly = .T.
...kt
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only