General information
Category:
Reports & Report designer
>>Hi all,
>>As the title say, how to change the unit of the ruler in report designer from centrimeter to inch.
>>TIA
>>charuwat
>
>VFP help says ( and I quote)....
>
>The scale for the ruler is determined by your system measurement settings. You can change from the system default scale (inches or centimeters) to pixels from within Visual FoxPro. If you want to change to the system default, change the measurement setting for your operating system.
>
>In my NT4 environment the setting is changed by using the Regional Setting control panel. Select the Numbers page, then change the measurement system.
Hi Mark,
Thank you very much
charuwat
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only