General information
Category:
Coding, syntax & commands
>>I know that the default printer and tray selection is stored in the FRX. How do I direct the system to print the report using a different printer tray without bringing up Print Setup?
>
>
>You could make a copy of the FRX file and then run the report three times, between every pass you change the EXPR field to the next tray.
>
Hello Christof,
thanks for the answer. I suspected this might be the only way to do it but somehow I was hoping there would be a simpler solution.
regards,
Alain
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only