General information
Category:
Reports & Report designer
>>>Hi Don,
>>>
>>>> did you mean set it to crsTemp?
>>>
>>>No, usually it should be sufficient to switch to the report cursor and run the report. Unless of course, some code or properties in the data environment change this.
>>
>>crsTemp IS the report cursor.
>>How do I set to property since it is readonly in the designer?
>
>Don,
>
>I'm sorry, but did you add NOFILTER to your select command? I bet it's creating a filtered view and thus you're getting the problem.
I did. Yes. It did not change the result.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only