General information
Category:
Forms & Form designer
Title:
Cannot see the entire form in development
I have not done VFP dev work in over 7 years. A company I did a project for wants a small enhancement. I am quite sure I can handle it but I hit an environmental (?) obstacle.
When I open up a form from my project, I cannot see the entire form and I see no way to expand the form. When I run the form, it all shows but when I view it in the Form Designer I can only see the top left 2/3 or so.
Sorry if my terminology is off.
Any suggestions?
Thanks.
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only