Sergey,

Thanks for your reply.

I installed a fresh copy of VFP as you instructed in our earlier thread. No SP1 was installed.

This is what I have done exactly on my new laptop:

1. Install fresh VFP9 from scratch.
2. Apply SP2
3. Apply the latest hotfix 968409 - http://code.msdn.microsoft.com/KB968409 (I followed the readme file instructions)
4. Get fixed SP2 help file from VFPx
5. Get updated XSource for Visual FoxPro 9.0 SP2

Perhaps, did I miss out on anything else?

Dennis



>Make sure that you don't have a mix of VFP runtime libraries from SP1 and SP2 on your PC.
>
>>
>>I recently installed VFP SP2 using the ff guidelines (thanks to Sergey Berezniker):
>>
>>1. Install fresh VFP9 from scratch.
>>2. Apply SP2
>>3. Apply the latest hotfix 968409 - http://code.msdn.microsoft.com/KB968409
>>4. Get fixed SP2 help file from VFPx
>>5. Get updated XSource for Visual FoxPro 9.0 SP2 if you're using it
>>
>>I then proceeded to recompile the EXE of my recent project.
>>
>>As I was test running each form via the executable, there were some forms which generate the typical MS error:
>>
>>Microsoft Visual Foxpro has encountered a problem and needs to close. - Send / Dont Send
>>
>>Clicking on any of the two, it will now show a C00000005 Exception code error with the ff:
>>
>>Fatal error: Exception code=C0000005 @ 08-15-2009 07:27:15 AM. Error log file: C:\Program Files\Common Files\Microsoft Shared\VFP\vfp9rerr.log
>> Called from - _application.execute line 53 {d:\vfp9dev\classes\base.vct d:\vfp9dev\classes\base.vct}
>> Called from - _application.execute line 59 {D:\VFP9Dev\CableAccess\programs\main.prg d:\vfp9dev\cableaccess\cableaxs.exe}
>>
>>If I ran the concerned form from the VFP IDE, it runs just fine!
>>
>>I traced my execute method _application object and found line 53 to be a "READ EVENTS". There is no line 59.
>>
>>Same behavior is also shown when I run my previous EXE file compiled in VFP SP1.
>>
>>Help!