General information
Category:
Forms & Form designer
>I want to change a form's class from an existing class to a more complex class on the same lineage. There's probably a simple way to tweak the .scx but I can't figure it out. Shouldn't be any problems since the new class has all the PEMs of the old + more.
>How do I do it?
Open the SCX directly, and change the CLASS and CLASSLOC values. Then, open the form with the Form Designer and check it. Did I remember to tell you to pray and to make a backup before? <g>
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only