Thank goodness, because going in and setting the boundproperty manually on every single control across 31 pages was daunting... :o) It's also the only form we have with more than a couple of pages :o)


>>Don't do it.
>>Well there's no harm in it as long as you recognize that if you make a subsequent change to a form in the designer the design.cs code is COMPLETELY regenerated
>
>Yes, Viv, that's the general rule of thumb, but it all depends on WHAT it is you've changed. As Tracy found out, that particular change didn't hurt anything, and her change was propagated into the regenerated code.
>
>~~Bonnie
>
>
>
>
>>>Update: It worked and didn't seem to break it :o)
>>>
>>>
>>>
>>>(Sorry, this is a Duplicate Post)
>>>
>>>Ok, the general rule is to leave the designer.cs file alone. However, the only thing I want to edit is the BoundProperty value on my controls. I am redoing a VFP form of 32 pages and each page has approximately 10-30 controls on it so updating the bound property on every page is very time consuming. Right now, the form has old variables in the boundproperty and I need to update every one with the new dotnet variable name. So, I want to parse the file and find:
>>>
>>>this.pgGenProp1.BoundProperty = "glMyVarName";
>>>
>>>and take the value glMyVarName, find it in a table, and replace it in the designer.cs file with "MyNewVarName" programmatically.
>>>
>>>I have a table with the old vars and the new vars.
>>>
>>>Can I do it? Has anyone done that before? As long as I don't touch anything else, is it reasonable for it not to break?