General information
Title:
Custom paper length ignored by Win95 or VFP5?
I am printing to contiunous forms on a Panasonic KXP-1124 dot-matrix. Length is 3" between perforations.
I have set custom paper size to 3" in Win95.
The report length is 3" on the ruler in Report Writer.
3 forms print correctly,
then it prints 3 more down 2" from where they should be,
then it prints 3 more down 1" from where they should be
(2" down from the last group,)
Then it prints 3 correctly, starting the whole cycle over again.
It is as if an 11" paper length is still being considered in the equation. (3 x 3" - 11" = 2" report creep)
What am I missing?
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only