General information
Category:
Installation, Setup and Configuration
Hi friends:
Since I started programming in VFP I set "Status Bar" = ON so if it is I set a particular path and default directory.
Then when I install the system CONFIG.FPW sets (or I think) "Status bar = off" and we all, I and my clients, are happy.
System executes in the correct fold.
You may imagine I'm here because that's not anymore... Any of you can imagine too what is changed?
Héctor
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only