>Hi Yuri,
>
>Thank you for the reply.
>
>>1. Are you sure that in VFP9 you create the very same data for the report? Is it possible, that because of enginebehavior it creates empty set?
>Yes I am using the same data, form and frx in VFP9 and VFP8. The engine behaviour in VFP9 is set to 80.
>
>>2. Does the report have objects in the data environment?
>None
>
>>3. Was report saved with "Save printer environment"?
>The report has no printer environment settings.
>
>It is hard to understand that why it should work in VFP8 and not in VFP9. Any more suggestions ???
Shafid,
Sorry, but did you compare final data set/cursor that you are getting before report form command? Are sets the same in 8 and in 9?
Other than that, is it possible to reproduce the behavior in simplest situation? Like create a final cursor, make a table from it, and then from VFP 8 and 9 command windows:
use this_table
report form ....
If so, then could you send to me table and report for reviewing?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only