General information
Category:
Reports & Report designer
>>>>>>>Also don't use private datasession for the report.
>>>>>>
>>>>>>im not..private data sessions isnt checked :(
>>>>>
>>>>>Do you get the same problem running this report in command window after opening the view?
>>>> OMG!!!!how do u kno it would work if i ran it from command!!!
>>>>no it works from command window. *GASP*
>>>
>>>It means that Sergey was correct and you're not selecting the right alias when you're running this report. Make sure that
>>>
>>>select ViewAlias
>>>report form ...
>>>
>>>commands are very close.
>>
>>ok...it works fine now! i probaby had the wrong table in an int somewhere. Thanks!
>
>You're welcome.
>
>BTW, when you get the solutions on your questions, you can mark them as such using buttons below your message (Solution or Help).
ok done /whispers didnt know
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only