General information
Category:
Reports & Report designer
Hi Dmitry.
A couple of ideas, makes sure the cursor is selected and you don't have the table setup in the label's data environment.
>Hi,
>
>I am having the following problem. The code selects certain number of records into a cursor. Then the cursor is selected and the command LABEL FORM is issued. But the LABEL FORM prints ALL records in the table from which the cursor was selected. I even checked right before the LABEL FORM (using BROWSE) that the cursor does have few records. I also tried closing the underlying table (from which the cursor is created). No matter what I do the LABEL report lists all records in the table. Is there a variable in the LABEL designer that I have to set to "something"? TIA
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only