General information
Category:
Coding, syntax & commands
Title:
File not open at endscan
Hi All,
I have a cursor named "toplamlar" which created with select command. A scan...endscan block uses that cursor and there are another methods in that block. At endscan line it gives "file not open" error. I can run "select toplamlar" before or after endscan so it means toplamlar open yet. I tried use nofilter with select command, no success.
At last I used old do while loop with skip command and there is no problem now. I wrote that message for just curious. Why that error generated?
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only