General information
Category:
Reports & Report designer
Hello Brenda,
I have used the same method suggested by Borislav successfully.
Actually I created a .dbf called PrntFile. It contains the combined fields from several tables. The report selection calls a .prg where I use PrntFile and append from 1st table. Then I have a few Do While/EndDo loops that open the other tables and Replace the data into PrntFile fields. The .FRX does not use Alias names so I can print from any dataset. Hope this helps.
Regards,
Paige
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only