General information
Category:
Reports & Report designer
AHA! client was using wrong report files (they were on a test system, but pointing to reports on the live system)!
Billable time for me <s>....thanks for the help anyway, appreciate it.
J
>Hello,
>
>I have a CheckFormLaser report that has a signature.jpg on it. When i run the port, the signature shows; when my client runs the report, nothing shows where the signature should be.
>
>Nothing is set in the PrintWhen tab of the report except "Print Repeated Values" which is Yes.
>
>The report is NOT built into the exe.
>
>The client can open the report and they see the signature (they sent me a screenshot).
>
>When they run the report no signature shows. No "foxHead" shows either (which is what happens if, on my system, i rename the signature.jpg so that the system can't find it).
>
>As far as i can tell, this is exactly the setup for another client (report and jpg are not in the exe, but the report prints fine, with the signature).
>
>Any ideas about what i am missing? i just sent them an exe w/the signature built in. I'll try building the report in next, but thought i'd ask here if anyone has any ideas.
>
>Thanks! Jill
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only