General information
Category:
Reports & Report designer
>You can't do it directly. Your reading of MSDN is incorrect.
>
>What you can do is create a cursor that holds all the detail data. The first row of the table would have all the data needed for each row of the report. In other words, you'd build the report data in the cursor. Then when you put the columns on the report, it would look like two detail bands.
>
>>Does anyone know where I can find a Tutorial on setting up a Report with Side by Side Multiple Detail Bands?
Thanks for your reply Craig..
Do you have any samples of this technique?
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only