General information
Category:
Third party products
>After reading about MTS for a few months, I'm finally trying to use it. I've created the component and it works fine on my PC. Now I need to run it remotely on a client PC. Everything I've read says that I can right-click on the package in MTS explorer and then export the package. A client install EXE is supposed to be created at the same time at the package file. However, no EXE is created when I do this. So, how do get the remote computer to know about the component that is running in MTS?
If you look in the directory you export the package to, there should be a directory 'client' in it. In that directory should be a setup.exe. (I think it is set up, been a few months since I did it)
That is the .EXE you are looking for.
BOb
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only