Level Extreme platform
Subscription
Corporate profile
Products & Services
Support
Legal
Français
'Printer not ready.' error in FPW 2.6
Message
General information
Forum:
Visual FoxPro
Category:
Troubleshooting
Miscellaneous
Thread ID:
00015419
Message ID:
00015512
Views:
41
>>>>I have a client who is getting get an error 125 - 'Printer not ready' once every two or three weeks. This system is being used all day, every day. After restarting the system, everything works again.
>>>>
>>>>I didn't know I could get this error under Windows!
>>>>
>>>>Any ideas?
>>>>
>>>>Thanks,
>>>>Shane
>>>I have the same problem in win 3.11, the spooler
>>>from printer manager hangs up when it gets to
>>>36 jobs aprox. The only solution I could find was to
>>>install win95
>>
>>
>>I have also run into this problem -- but the max number of print jobs I could get out was 32. You have to exit Windows to reset. As Claudio alluded to, you have to upgrade to win95 to solve this problem.
>>
>>Best of luck!
>>
>>Valerie
>
>the print routine in fpw2.6 is infamous for 'losing' memory. we had a situation where one of our clients could print 50-60 invoices at a time before this happened. the original design had a loop around the report form to printer command (bad design). we replaced it with a report form to printer for [range of invoice numbers]. this took only one report command but would print until they finished (or hit a paper jam).

How about flushing the printer? Set Printer To, then Set Printer to LPT1. I used this approach to solve some problems on the pathworks network in the past. Also, is this bug documented? I can't believe MS does not have a patch. I know several patches to Win 3.x exist. I personally have never used any... The limit on number of print jobs is by design MS will tell U anyway...
Steve Medvid
Systems Analyst

Environmental Resource Management
Previous
Reply
Map
View

Click here to load this message in the networking platform