Rick,

sorry, I can't remember what the errors were but I did sort the problem out last week by manually compiling each project one at a time. If the solution is setup with two project sand one is set to depend on the other, shouldn't it always compile in the correct order?

>What kinds of errors?
>
>Sometimes this happens because some other part of the Solution is not compiled or compiled out of order. Try a rebuild all, and if that fails start with the least dependent project up to the the hierarchy.
>
>+++ Rick ---
>
>
>>Hi,
>>
>>I have an application which runs fine when I have the solution configuration set to debug. When I change it from Debug to Release I then immediately get loads of errors.
>>
>>What's going on here?