Information générale
Catégorie:
Installation et configuration
>>I did search the archives, but didn't find any comments on this one ...
>>
>>I just replaced an old stand-alone computer with a new Window 7 computer.
>>
>>I run a number of VFP 6 apps on this system, and need that version of the development system loaded.
>>
>>VFP 6 loaded fine.
>>
>>SP5 hung, saying it needed MDAC 2.5 or better. Running the load from the SP5 disk does not good.
>>I'm sure Windows 7 handles the issues "a better way."
>>
>>I see on other support sites mention of this problem, but I don't see a work-around.
>>
>>Would just running this apps under VFP 7 avoid the problem?
>
>If you haven't already, you could try running the VFP6 SP5 installer or the MDAC installer as Administrator i.e. right-click on the EXE or MSI and select "Run as administrator".
------------------------------------------------------
2:30 EDT 4/18/13
I ran them both (setup, then mdac_type, then setup again) all as administrator.
No change in behavior.
I am the sole user (my notebook) of this computer, and am an "administrator". If I am an administrator, should I have to "Run as administrator" to get better results (which didn't happen in this case?"
Thanks,
Dennis
Précédent
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement