Hi Gang!
I am having a brain poopoo at the moment.
I want to save my work area before going into some code that may or may not run.
After the code is finished, I want to go back to my saved work area
I started like this..
lcRx_No = ''
lnSelectedWorkArea = SELECT()
IF NOT USED('rx_107')
USE IN 0 rx ALIAS rx_107 AGAIN
ENDIF
SELECT rx_107
IF This.m_seek(rx.rx_no,'rx_107','UPDATEDRX')
lcRx_No = ALLTRIM(STR(rx_107.rx_no))
ENDIF
USE IN SELECT('rx_107')
IF lnSelectedWorkArea > 0
SELECT &lnSelectedWorkArea
ENDIF
It saves the work area ok in lnSelectedWorkArea
but the SELECT &lnSelectedWorkArea gives an error "Command contains unrecognized phrase/keyword"
So, what did I do wrong here? Thanks!!!
Tommy Tillman A+ NetWork+ MCP