>>Hi Gang!
>>
>>I am having a brain poopoo at the moment.
>>
>>I want to save my work area before going into some code that may or may not run.
>>
>>After the code is finished, I want to go back to my saved work area
>>
>>
>>I started like this..
>>
>>
>>lcRx_No = ''
>>lnSelectedWorkArea = SELECT()
>>IF NOT USED('rx_107')
>> USE IN 0 rx ALIAS rx_107 AGAIN
>>ENDIF
>>SELECT rx_107
>>IF This.m_seek(rx.rx_no,'rx_107','UPDATEDRX')
>> lcRx_No = ALLTRIM(STR(rx_107.rx_no))
>>ENDIF
>>USE IN SELECT('rx_107')
>>IF lnSelectedWorkArea > 0
>> SELECT &lnSelectedWorkArea
>>ENDIF
>>
>>
>>It saves the work area ok in lnSelectedWorkArea
>>
>>but the SELECT &lnSelectedWorkArea gives an error "Command contains unrecognized phrase/keyword"
>>
>>
>>So, what did I do wrong here? Thanks!!!
>
>Use instead
>
>select (m.lnSelectedWorkArea)
>
>And you don't have to test if it's >0 or not.
Thanks!
Tommy Tillman A+ NetWork+ MCP