General information
Category:
Coding, syntax & commands
Title:
VFP editor command format
After a re-install of VFP following a hard drive crash, the prg and method commands (seek, locate, endif etc) now switch to SEEK, LOCATE, ENDIF, etc. when I type them in. I used to have this upper case re-formatting turned off, but I don't remember where this is set, so I can get back to lower case commands. I can do it with Beautify, but I want it done the way I write it as I go. Any thoughts?
Bob
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only