General information
Category:
Reports & Report designer
>>>I have received a request to print 3 part business checks, where the actual check is the MIDDLE stub, while the check details (or line items) are printed on the top stub and REPEATED on the bottom stub.
>>>
>>>For years I have been doing something similar for 3 part checks, where the actual check is the TOP stub, but not the middle stub. (and the line items were NOT repeated)
>>>
>>>It sounds like i need two DETAIL bands, repeating the records from the same table, or a second copy, and a HEADER or GROUPING located in the middle of the frx.
>>>
>>>Just not sure how to best proceed. Any recommendations?
>>
>>Bump. Any suggestions? Thanks.
>
>SBT puts the check and the Top Stub in the header and the bottom stub in the detail band
>
>All data comes from memvars.
>
>
>Here's a picture.
>
>To get the check on top, just reverse the order in the header band.
Thanks Bill. I will give it a try.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only