Try:

SET PRINTER TO LPTx
SET DEVICE TO PRINTER

And use @...SAY commands to send data to printer.

It may work...

Vlad

>I have a need to read in an acad file then do some conversion of positions and lengths then send data out to the parallel port to drive a stepper motor. The FoxPro part is not a problem. However, the communication to the parallel port is another story. How can I bridge the gap between VFP and the parallel port? I did a very little C programming a long time ago and have cracked open my Visual C++. What a difference... Any suggestions on how to approach this will be appreciated.
>
>
>Thanks