General information
Category:
Reports & Report designer
>Hi,
>
>I need to move some fields on the report 5mm (approximately down). The VFP 9 report designer has a grid which looks like 1cmx1cm (with half line visible). Would it be correct to assume that if I move an object by a grid section, it would be translated to 5mm (half of 1cm)?
>
>TIA
If you look at the bottom, you can see the exact position in inches. Every 1mm is 0.0394". So, adjust things up/down by as much as you need. 5mm = 0.1969".
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only