Information générale
Catégorie:
Gestionnaire de rapports & Rapports
>Hi,
>
>I need to move some fields on the report 5mm (approximately down). The VFP 9 report designer has a grid which looks like 1cmx1cm (with half line visible). Would it be correct to assume that if I move an object by a grid section, it would be translated to 5mm (half of 1cm)?
>
>TIA
If I remember correctly, the location and size units are configuration-dependent (basically on the locale) so it's either in fractions of inches or fractions of centimeter (I vaguely recall it was something like ten thousandths of inch or thousandths of ceintimetre) -- with one of the "header" records giving you the units used throughout.
Précédent
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement