Plateforme Level Extreme
Abonnement
Profil corporatif
Produits & Services
Support
Légal
English
Keypress problems
Message
De
14/12/1998 01:01:35
 
 
Information générale
Forum:
Visual FoxPro
Catégorie:
Codage, syntaxe et commandes
Divers
Thread ID:
00167079
Message ID:
00167087
Vues:
24
>>FoxPro's DEFAULT KeyPress code needs to receive the parameters just like the code above does. Replace DODEFAULT() with DODEFAULT(nKeyCode, nShiftAltCtrl) and give it another try.
>
>Thanks for the idea Bob, however I still have the same strange behavior... fields getting skipped on Tab and the "Property Value not found" error.

If you haven't seen this before, at least I can confirm that it's not supposed to happen. Must be some more general thing is going on. Actually, without the parameters being passed, you should have had other problems so I suspect that your code IS NOT being run ... something else is.

Check the root level of the form for the KeyPreview property. It must be set to .t. for your form level KeyPress code to work. Otherwise, the KeyPress code attached to each control is what gets used. In my system these are all empty. The KeyPreview property is used to allow the form to handle KeyPress events before the active control processes them.

Bob
Précédent
Suivant
Répondre
Fil
Voir

Click here to load this message in the networking platform