General information
Category:
Coding, syntax & commands
I changed my commands in the command window to ...
lcStatus = "Customer"
SELECT vTest
INSERT INTO vTest (firstname,lastname,status) ;
VALUES ("Joe","Smith","Customer")
llUpdate = TABLEUPDATE()
? llUpdate
lnRequery = REQUERY('vTest')
? lnRequery
BROWSE
... and it displays .T. for llUpdate and 1 for lnRequery, which indicate everything worked correctly. Again the data DOES make it into the base table, but the view does not display the new record in the view. If I close everything and reopen the view, set the parameter (lcStatus) and do requery, then the new record does appear in the view. But I shouldn't have to close the view to get the update righ?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only