Mark,

I've done this with some success. The only thing I make sure to do is not change the orientation by blanking out Expr completely. Here's the code I use. It assumes the current directory is where the report and/or label files are.

SET MEMOWIDTH TO 1024

DIMENSION aFileType[2]
aFileType[1]='*.FRX'
aFileType[2]='*.LBX'

FOR EACH cFileType IN aFileType

  nNumReps=ADIR(aReps,m.cFileType)

  FOR i=1 TO nNumReps
    USE (aReps[i,1])
    LOCATE FOR ObjType=1
    IF FOUND()
      REPLACE Tag2 WITH ''
      m.cExpr=Expr
      FOR j=1 TO MEMLINES(m.cExpr)
        m.cLine=MLINE(m.cExpr,j)
        IF m.cLine='ORIENTATION'
          EXIT
        ENDIF
      NEXT
      REPLACE Expr WITH IIF(m.cLine='ORIENTATION',m.cLine,'')
    ENDIF
  NEXT
ENDFOR

>Hi ,
>I'm creating reports using the VFP report designer & just before I send a new report to my clients I intend to open the report's .frx file, go to record 1 & replace tag, tag2 & expr with "". Is this all I need to do to ensure the report will run properly on different printers. This sounds almost too easy to me. Does anyone know of any problems with this approach?