General information
Category:
Coding, syntax & commands
>We fired up the coverage profiler in VPF 6.0 today. I think it would be very useful, except that the initial time and average time displayed is only to 3 decimal places. Almost all lines show a time of 0.000. This is not much use! What is up with this? Any ideas or suggestions?
>
>Thanks
>Dean
I'm sorry, but, 0.000 tells you that the line takes 0.0009 or less to run. What is the difference if the line runs in 0.0006 or 0.0008...? Do those 2 miliseconds really make much difference?
What could you do to make the line run faster? I would say, look at the lines that have something to the left of the decimal!
BOb
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only