General information
Category:
Reports & Report designer
>David, have you read the Dragan's reply?
>It seems that it is possible to do it using 3 report variables.
>Vars are calculated in the order as they apper in the variable list.
>
>The trick is that second variable expression uses inside iif()
>the value of third variable. This allows to sum previous group when
>in the next group header !
>This work faster since calling udf from reports is slow.
>What do you think about this?
>
Well I would have thought it possible. And that's what I was attempting when I came up with the solution I sent you. I wouldn't normally worry about calling UDFs from a form, unless there's 10000's of them. I would worry about keeping it understandable and it's easier to document a UDF (prg) than the report form variables.
>I tried to use Lisa's coolbutton class but without success.
>She wastes her time for application generator as I read from her
>article in the ms vfp site.
I haven't been following what Lisa's been up to lately. I think perhaps, her application generators are "too" clever and may take an above average commitment (and knowledge) to master. I don't know, I only say that because of what I know about her.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only