General information
Category:
Reports & Report designer
>How do I get the results of my select into my report .FRX?
>
>I do a DO .FRX command after the SELECT command in my .PRG to call/run the report .FRX
Steve --
It looks like your next logical step is to run the report. First, make sure that the cursor you created is the currently selected work area (SELECT MyCursor), then execute the report with REPORT FORM MyReport.
The REPORT command has several handy options, so you may want to check out the on-line help for a full explanation of this command.
HTH -- Bill
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only