>I would like to distribute my application on CD and enable the Autorun feature. I did this numerous times in VFP5 successfully, but I'm getting an error in VFP6. As per Article Q172078, I renamed the setup.exe to autorun.exe. But when I run the autorun.exe, after a few steps I get a message saying that the file 'setup.exe' cannot be opened. Of course it can't, it no longer exists, but why is the installation looking for it? I tried this with both the 'netsetup' option and the 'websetup' option and had the same problem. I've already upgraded my Setup Wizard. Anyone else do this successfully?
>
>Thanks!

Looking at a typical AUTORUN.INF file the following lines should suffice:

[AutoRun]
open=setup.exe

Assuming SETUP.EXE is in the root directory of the CD. The AUTORUN.INF file also needs to be in the root directory of the CD.

If you put all your install files in a directory on the CD, change the lines to:

[AutoRun]
open=relative_directory_path_here\setup.exe

Just do not precede the directory path with a drive letter.