Plateforme Level Extreme
Abonnement
Profil corporatif
Produits & Services
Support
Légal
English
Switch to VFP5 or VFP6 ?
Message
Information générale
Forum:
Visual FoxPro
Catégorie:
Autre
Divers
Thread ID:
00181320
Message ID:
00181475
Vues:
10
Is the C000005 error a problem with NT Workstation 4.0 (SP3)?

I seem to recall that it wasn't, but I might be mistaken.

We are in the same boat (3.0 to 5.0 or 6.0?) I want to go right to 6.0, but I want to wait for a major service pack release before making the switch.

Thanks,
Joe

>>The question is, should I develop with VFP 5 while waiting for a real patch for VFP 6, or work with VFP 6 because maybe I won't get affected by the C0000005 error?
>
>There's a lot of variance with that error, from all the messages here. The one standard vfp6-created application runtime C000005 error can be corrected with DCOM/IE4 installation. That may be enough concern to cause you to rethink 6, or maybe not. Other than that, they're pretty much all development errors. I've been using 6 and beta-6 since May 98, and have only seen that error maybe 2 or 3 times, none recently. But others have seen plenty of them.
>
>If you have 6, you could go ahead and start using it for a new project -- MS may have a patch for it before long, and if you do have C000005 trouble, you'll probably bump into it pretty quickly developing in 6, so can downgrade to 5 without too much lost time if need be...
Joseph C. Kempel
Systems Analyst/Programmer
JNC
Précédent
Suivant
Répondre
Fil
Voir

Click here to load this message in the networking platform