Hello Doug!
I have the same problem with "floppy disks setup",but Netsetup worked properly.
Ilya
>Ok, the project has been finished, all files compiled and errors eliminated. I >built the project, and all went well too. I then built the excutable. oops! (This is on an NT4.0 machine) I double click on the executable and it loads. >Nothing appears on the screen, but in checking NT, it shows the process as >loaded.
>I end that process, then load VFP. Then by giving the command line
>of "DO xx.exe" the program loads and runs like it is supposed to.
>When I use the set up wizard to create the installable, it also runs just >fine, creating the setup program, cab files, etc. When I try to run the set up >program, it will create the subdirectories, then errors out. The message is >"There is an error in setup.exe. Run it again" But running it again produces >no installation and the same error. What am I forgetting to do here?
>Doug White
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only