General information
Category:
Coding, syntax & commands
>>I'm using the command CLOSE TABLES ALL in a form's method
>>
>>The line causes the error "Cannot access selected table"
>>
>>My error handler should fire but does not...
>>
>>Any ideas why?
>>
>>TIA
>
>One of the tables was closed prematurely. There is probably a form reference to the table.
But why doesn't this cause my ON ERROR routine to run?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only