Hi -

I came across a problem when I use my form wizard to create forms for my application. I am getting an error message after after I complete the form wizard prompts and save the form. Error #111 pops up on the screen.

Error #111 says "you attempted to write a file that was created or accessed for read only purposes"

So, I went to may handy dandy FoxPro book and starting reading about read only files.

My question is this:
How should I set up my application so this isn't a problem, especially in the design phase? How do I tell FoxPro to make a program or file read only?

Thanks for any comments/help in advance

Jason