Hi Erik -

I have a question that I hope you could help me with. You have been so helpful to me in the past I wanted to run something past you to see if you had any idea what my problem is. I hope that is ok?

I want to create forms for my tables, so I am using the form designer and finish a particular form. When I close the form, I get prompted whether to save the form, for which I say yes, and for some reason FoxPro kicks me into the application builder.

So, at this point, I am looking at my newly created form in the App. Builder on the forms tab. When I click OK I get an error message that says:

Error # 111
Method - adjustproperties
Line # - 54
Message - cannot update the cursor
Line - REPLACE Properties WITH lcProperties

Would you like to continue?

If I choose Ignore, nothing happens.... If I choose Retry, the Debugger pops up, and If I choose Abort nothing happens.

When I close the error box and then the application builder, my form I just created is situated just fine in my application, but this shouldn't be happening.

If you have any idea or remedy for my little problem, I would sure appreciate your feedback. If it has to do with working in the debugger, I could be in trouble, b/c I have never done that before and would need very explicit instructions.

Thanks again Erik

jason