General information
Category:
Reports & Report designer
If you mean the UnPrintable Area Setting in properties they are set to 0.
but I'll check again.
>Andy, just a guess, but could your default margins be different on the different printers? These defaults are set for each printer on each PC.
>
>HTH
>Barbara
>
>>I keep getting an error in a label of "Detail section to large for page size" in VFP 5. I have defined the label size as 5 wide and 3 deep and set the page size to custom of 5" x 3" (settings are 500 & 300) saved it and when I print this to an Okidata 321 over the network all is fine from my pc or the shipping pc. I print to another Okidata over the network I get the error from the shipping pc. If send it to a Panasonic 1624 on LPT 1 of the shipping pc I get the error. I define the panasonic printer on my PC it works fine.
>>
>>All printers have the same custom page size set of 500 by 300 (5"x3")
>>The label in the label designer is 5" wide and I have adjusted the vertical size down to 2 1/2 with no header or footer and left the page size the same.
>>
>>I have made the page size 600 x 1200 hoping to get 4 on it, in the custom paper size of the printer but that didn't work either.
>>
>>How can I solve this problem?
>>
>>Thanks
>>Andy
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only