Level Extreme platform
Subscription
Corporate profile
Products & Services
Support
Legal
Français
Select 0 Error
Message
From
07/02/1997 11:38:26
 
 
To
06/02/1997 14:56:27
General information
Forum:
Visual FoxPro
Category:
Troubleshooting
Title:
Miscellaneous
Thread ID:
00019477
Message ID:
00019589
Views:
34
>>I have a line of code that has suddenly, after two years, turned on me. It is, simply:
>>
>> Select 0
>>
>>It is now sporadically returning a Data type mismatch error.
>>
>>This is in FPW 2.6; anyone have any ideas? Yes, the 0 is a zero, not an O.
>>
>>I have a similar strange error with these lines:
>>
>> If Used('Qpers')
>> Use in Qpers
>> Endif
>>
>>This is also returning a data type mismatch, on the second line.
>>
>>This is a mature application, and I haven't changed anything in either of these two routines, so it has to be something external that is affecting this.
>
>Two guesses here:
>
>The application has become corrupted or FoxPro has become corrupted.
>

Craig, I would investigate the previous command/line Also, some times I have seen when viewed with a hex editor My prgs have a 20... Well anyway it looks like a space but it is not and foxpro reads it that way. You can also try to retype the sele 0 on the next line (no cut'n'paste) then delete the existing line.

HTH
~Joe Johnston USA

"If ye love wealth better than liberty, the tranquility of servitude better than the animated contest of freedom, go home from us in peace. We ask not your counsel or arms. Crouch down and lick the hands which feed you. May your chains set lightly upon you, and may posterity forget that ye were our countrymen."
~Samuel Adams

Previous
Next
Reply
Map
View

Click here to load this message in the networking platform