I have an application that I built with VFP 5 and convertet to VFP 6. I used the treeview conversion utility and the forms using the treeview work fine. If I go to the VFP Options and look under ActiveX controls the version 6 of these controls is selected. At least I think the correct ones are selected. The names are wider than the listbox and it is not resizable, but the one with the current focus displays at the bottom of the form. However when I go to the Setup Wizard the V 6.0 Active X controls do not show up in the listbox so I cannot select them to include in my distribution, and if the target machine does not have VFP development already installed the forms with the treeview do not work. I have another machine that I think was configured the same way and when I run setup on that machine the version 6 controls do show up in the list and a workable distribution can be generated. The development machine that does not work is NT4 SP4 and the others are WIN98.