Hi John ---

Divorce the user from the OOP....If you have saved the info, then SEEK to find the right property setting and restore it as follows

cName=THIS.Name
SELECT mysettings
SEEK m.UserID+cName
IF FOUND()
cProperty=mysettings.property
*** Set as appropriate...!!!
ENDIF

>
>I have managed to save the .Width, .Name, .ColumnOrder of the columns in the grid to a table. I can't however figure out how to reference the columns using the column name stored in the table to reset the .ColumnOrder.
>
>After I find the record in the table for that grid how do I use the User.ColumnName that is stored in the table in the "This." statement?
>
>This."User.ColumnName".ColumnOrder = User.ColumnOrder
>
>Each attempt results in an syntax error...
>
>Thanks
>
>>And/or Release. Not Destroy, though, IMHO.
>>
>>>
>>>Would the Destroy event be the same as the QueryUnload? I see that the QueryUnload is not called if you invoke the forms Release method, could this be a potential problem?
>>>
>>>Thanks
>>>
>>>>Hi John ---
>>>>
>>>>There's no easy answer to this. You could store these properties to a table on QueryUnload and restore them at Form Init. Or substitute the table for registry settings or INI settings.
>>>>
>>>>
>>>>>How can I store the ColumnOrder and Width when the user modifies a grid?
>>>>>
>>>>>Thanks