I have the same problem you described about running an exe from the menu. If it's a foxpro 2.6 executable, you can can simply use "do myexe.exe". But my problem is that I'm trying to use the "run /n" command and it seems that the foundation read takes over after the run command was executed and brings the original application on top and the exe I just ran is in the back ground.
Did you ever figure out your problem, and do you have any suggestions for running a non foxpro exe
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only