General information
Category:
ActiveX controls in VFP
>Noticed a few weeks back someone asked if the Date & Time picker was actually being used. Seemed the answers were inconclusive.
>
>May I raise the issue again? Is anybody successfully using it, especially in grids?
>
>As always, TIA...
In my opinion, due to the fact that you can not put an empty date or a null date into the control without getting an invalid date message, it is not usable...
The main place where I see it would be usable was when it was always going to be bound to a memory variable that started at some default date, perhaps to select ranges for a report, etc...
BOb
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only