General information
Category:
Reports & Report designer
>2. Again on each workstation, open the properties of lapbptr and select paper and then custom size. Since the labels they are using are the typical 3.5" X 1" labels, I define the custom size as 350 by 100 (units are .01 inches)
Hi Potter, this sounds like a good solution to this but I don't see where
you are seeing an option for "Custom" paper size. In the Windows NT
Print Setup panel, I see something like:
Printer section:
* Name, Status, Type, Where, Comment and [Properties]
Paper section:
* Size "Letter", Source "Automatically Select".
Orientation:
* Portrait, Landscape
Under the Paper section, the Size combobox has:
A4 - A5
B5
Envelope XXX where XXX is a number of different non-obvious choices
Executive
Legal
Letter
Letter Small
Note
However, I see no "Custom" option??
Thanks for the note.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only