Level Extreme platform
Subscription
Corporate profile
Products & Services
Support
Legal
Français
Exes crashing even after sp3
Message
From
28/06/1999 18:47:12
 
 
General information
Forum:
Visual FoxPro
Category:
Other
Miscellaneous
Thread ID:
00234770
Message ID:
00235007
Views:
26
>
>You may have a problem with the version of DCOM installed on your system; if the registry entry HKEY_LOCAL_MACHINE\Software|Microsoft\OLE isn't present, you need to take the appropriate steps to install DCOM on your system, as I've outlined in the FAQ here on UT, and as discussed in an MSKB article based on the FAQ entry here.

did all that last week. Or rather, checked it. Already installed

>
>If you uninstalled VS6 under NT, where you had installed any Service Packs subsequent to the initial VS6 install, you'll probably have to reapply the NT Service Pack, since uninstalling VS6 may have resulted in restoring an older version of a shared component updated by both VS and the Service Pack. I'd advise installing NT SP5 if you can, and if IE5 is installed, make certain that version 5.00.2314.1003 is installed.
>

yup thats the one I have...

again though, you refer to VS6, I'm a humble vfp only user, is there a possibility that this means I'm missing a possible fix that only comes with vs6 or should I have flushed something else in me de/reinstalls?

Harry
Previous
Next
Reply
Map
View

Click here to load this message in the networking platform